Fillers
Home - Products - Marine Line - Yachting Line - Fillers - Epoxy Light Filler 21
Epoxy Light Filler 21

Epoxy Light Filler 21

pdf-icon
Code: 7F6458 + 8Z6459

Two-component epoxy filler for high thickness applications, with low specific weight, designed for levelling surfaces of boats in iron, aluminium or light alloys, as well as cement masonry in general. Highly flexible filler, easy to apply in a single coat. Its low specific weight helps reduce the load of the applied product on the coated structure. Widely used in painting cycles for boats, it withstands significant temperature variations without sagging, thickness loss, or application issues. This filler is the result of extensive research and testing in direct collaboration with professional applicators, which enabled us to develop this high-quality product. It is also suitable for application on fiberglass hulls, provided they are sufficiently rigid and thick (to avoid possible coating deformations). This product has been specifically tested for use as support strips for teak decks on luxury boats

SURFACE PREPARATION AND APPLICATION CYCLE

Iron. Sandblasting to SA 2.5 grade. Apply one coat of EPOFOND AM/9 primer. After 12 hours, sand and apply EPOXY LIGHT FILLER 21, allowing to dry for 24-48 hours. Apply PLAMUR FINISHER LIGHT if necessary, to achieve a perfect levelling. Sand and proceed with the selected finishing cycle.

Aluminium and light alloys. Mechanically remove the oxidized surface layer. Remove dust and surface residues and degrease with Thinner 765. Apply one coat of EPOFOND AM-9 primer. After 12 hours, apply EPOXY LIGHT FILLER 21, allowing to dry for 24-48 hours. Apply PLAMUR FINISHER LIGHT if necessary, to achieve a perfect levelling. Sand and proceed with the selected finishing cycle.

NB: This product is also part of the Skipper’s Nautical Line; for further information regarding this sector, please also consult the complete painting cycles for boats made of Wood, Iron, Aluminium or Fiberglass, available on request. www.aemmecolori.it

Paint Type Two components
Binder type A Epoxy
Binder type B Ammine adduct
Code & colour A 7F6458 Light blue
Code & colour B 8Z6459 Cream
Specific gravity kg/lt (±0,05) 0,550
Viscosity Ford ø 8 at 20°C ±2 Thixotropic (A+B)
Shelf life +23°C (±2) 12 months in unopened cans
Application Dilution
Mixing ratio A+B by volume 2 parts Sol.A with 1 Sol.B
Pot life A+B (20°C) use within 1 hour
Sandable After 24 hours
Touch dry 3-4 hours (20°)
Spatula Ready to use
Recoat time 24-48 hours (20°)
Application temperature Between +10 C and +40 C
Relevant humidity Less than 80%
Dry film thickness advised From 0.5 to 3 cm per coat
Theoret. coverage m2/Lt 0.1 at a thickness of 1 cm
SAFETY PRECAUTIONS

Before starting paint application please carefully read all the safety precautions indicated on the label of each can or in the product safety data sheet available on request. For further information please do not hesitate to contact our technical staff.

NOTES

The above information is given to the best of our current knowledge, however, because the conditions of use of our products are beyond our control, no warranty is given or to be implied in respect of such information. Our technical staff can be contacted to study customer's specific requirements involving our products in order to enable their most effective use. Dilution rates and drying times must be considered only indicative, mainly related to a temperature of 20 ° C (68°F) and may vary according to prevailing temperature, in presence of particular weather conditions or depending on application procedures.