One-component zinc-rich epoxy based coating providing easier application than two-pack products of this kind; it is also used for small carpentry projects and where a high quality anti-corrosive protection is required. Also recommended as a maintenance coat for hot-galvanizing process.
SURFACE PREPARATION AND APPLICATION PROCEDURE
Bare Steel. Sandblasting to SA 2,5 is requested before application of Epozinc 1C primer coat. Apply EPOZINC 1C diluted 5-10% with THINNER 400.
| Paint Type | One component |
| Binder type A | Alkyd modified |
| Specific gravity kg/lt (±0,05) | 2,22 |
| Solids content (volume) ±2 | 31% |
| Viscosity Ford ø 8 at 20°C ±2 | 26 sec. |
| Application | Brush-Roller-Spray |
| Brush-Roller | 5-10% Diluent 400 |
| Spray | 5-10% Diluent 400 |
| Touch dry | 15-30 minute (20°C) |
| Recoat time | 12-24 h (20°C) |
| Application temperature | Between +10 C and +40 C |
| Relevant humidity | Less than 80% |
| Dry film thickness advised | 50 microns by hand |
| Theoret. coverage m2/Lt | 4-5 |
Colors: GRIGIO
Color code: 5I0000
Before starting paint application please carefully read all the safety precautions indicated on the label of each can or in the product safety data sheet available on request. For further information please do not hesitate to contact our technical staff.
The above information is given to the best of our current knowledge, however, because the conditions of use of our products are beyond our control, no warranty is given or to be implied in respect of such information. Our technical staff can be contacted to study customer's specific requirements involving our products in order to enable their most effective use. Dilution rates and drying times must be considered only indicative, mainly related to a temperature of 20 ° C (68°F) and may vary according to prevailing temperature, in presence of particular weather conditions or depending on application procedures.
Seguici su
Tel:
Fax:
Email -
PEC -
© Aemme Colors 2022 - All rights reserved.
Cookie Policy - Privacy Policy