One-component primer for low thickness direct application onto fibreglass boat bottoms. Also recommended as a primer coat before antifouling application and as a tie-coat between epoxy or polyurethane two-component paints and one-component finishes. Overcoatable with TOPKAPI enamel for topside and superstructure finish or with appropriate antifouling paint for boat bottom finish.
SURFACE PREPARATION AND APPLICATION PROCEDURE
Bare Fibreglass. The surface to be coated should be perfectly cleaned, degreased with suitable detergent solution, rinsed with water and slightly sandpapered with fine abrasive paper. Remove dust particles from the surface. Apply 1 coat of UNIFIBER PRIMER and let dry 6-8 hours. After 24 hours apply 1 coat of intermediate undercoat (SOTTOFONDO NAUTICA for topsides or SOLVER PRIMER for the bottom) and let dry as recommended. After 6-8 hours sandpaper the surface and complete the coating system with 2 coats of recommended one-component topcoat enamel for topside and superstructures or 2 coats of antifouling paint for the bottom.
Previously Coated Fibreglass with 2-component paint. The pre-existing paint should be in good condition of adhesion to the substrate. Sandpaper and apply 1 coat of UNIFIBER PRIMER and let dry 6-8 hours. Apply 1 coat of intermediate undercoat (SOTTOFONDO NAUTICA for topsides or SOLVER PRIMER for the bottom). After 24 hours sandpaper the surface and complete the coating system with 2 coats of recommended one-component topcoat enamel for topside and superstructures or 2 coats of antifouling paint for the bottom.
| Paint Type | One component |
| Binder type A | Vynil modified |
| Specific gravity kg/lt (±0,05) | 1.180 |
| Solids content (volume) ±2 | 24% |
| Shelf life +23°C (±2) | 30 months in unopened cans |
| Viscosity Ford (Ø4 a 20°C) | 50 sec. |
| Application | Brush-Roller-Spray |
| Brush-Roller | 0-5% Thinner 765 |
| Spray | 10-20% Thinner 765 |
| Touch dry | 20-30 minutes (20°C) |
| Recoat time | Minimum 6 h (20°c) |
| Application temperature | Between +10 C and +40 C |
| Relevant humidity | Less than 80% |
| Dry film thickness advised | 15 microns per coat |
| Theoret. coverage m2/Lt | 10 |
Colors: VERDE
Color code: 4S4705
Before starting paint application please carefully read all the safety precautions indicated on the label of each can or in the product safety data sheet available on request. For further information please do not hesitate to contact our technical staff.
The above information is given to the best of our current knowledge, however, because the conditions of use of our products are beyond our control, no warranty is given or to be implied in respect of such information. Our technical staff can be contacted to study customer's specific requirements involving our products in order to enable their most effective use. Dilution rates and drying times must be considered only indicative, mainly related to a temperature of 20 ° C (68°F) and may vary according to prevailing temperature, in presence of particular weather conditions or depending on application procedures.
Seguici su
Tel:
Fax:
Email -
PEC -
© Aemme Colors 2022 - All rights reserved.
Cookie Policy - Privacy Policy