Special two-component primer formulated to provide excellent adhesion to fibreglass surfaces. It is applied as a basecoat on topsides, superstructures and hulls below the waterline of fibreglass boats. It can be applied direct onto gelcoat provided that a suitable surface degreasing and light sanding with fine abrasive paper is being carried out before its application
SURFACE PREPARATION AND APPLICATION PROCEDURE
Fibreglass or Plastic. The surface to be coated should be degreased with suitable detergent material, rinsed and slightly sanded with fine abrasive paper. Remove dust and clean the surface. Apply one coat of POLIFIBER PRIMER followed if required by a second coat in the event the of a particularly rough surface. After 24 hours sand with fine abrasive paper and follow up with the recommended coating system.
| Paint Type | Two components |
| Binder type A | Polyester |
| Binder type B | Isocyanates |
| Specific gravity kg/lt (±0,05) | 1,685 (A) - 1,040 (B) |
| Solids content (volume) ±2 | 35% |
| Shelf life +23°C (±2) | 24 months in unopened cans |
| Viscosity Ford (Ø4 a 20°C) | 40-60 sec. (20°C) |
| Application | Brush-Roller-Spray |
| Mixing ratio A+B by volume | 10 parts Sol.A with 3 Sol. B |
| Pot life A+B (20°C) | use within 4-6 hours |
| Brush-Roller | 15-30% Thinner 203 or 205 |
| Spray | 25-35% Thinner 203 |
| Touch dry | 2-3 h ( 20°c) |
| Recoat time | 18-24 h (20°c) |
| Application temperature | Between +10 C and +40 C |
| Relevant humidity | Less than 80% |
| Dry film thickness advised | 50 microns per coat |
| Theoret. coverage m2/Lt | 10 |
Colors: BIANCO
Color code: 4S4182
Before starting paint application please carefully read all the safety precautions indicated on the label of each can or in the product safety data sheet available on request. For further information please do not hesitate to contact our technical staff.
The above information is given to the best of our current knowledge, however, because the conditions of use of our products are beyond our control, no warranty is given or to be implied in respect of such information. Our technical staff can be contacted to study customer's specific requirements involving our products in order to enable their most effective use. Dilution rates and drying times must be considered only indicative, mainly related to a temperature of 20 ° C (68°F) and may vary according to prevailing temperature, in presence of particular weather conditions or depending on application procedures.
Seguici su
Tel:
Fax:
Email -
PEC -
© Aemme Colors 2022 - All rights reserved.
Cookie Policy - Privacy Policy