Two-component epoxy finishing filler applied at low thickness for smoothing small and large surfaces of boats. Used in two-component coating systems. Once sanded provides a smooth and even finish ready to be overcoated.
SURFACE PREPARATION AND APPLICATION PROCEDURE
Steel. Sandblasting accordingto SA 2,5. Apply a first coat of EPOFOND AM-9 and let dry. Sandpaper and apply EPOXY LIGHT FILLER NS and let dry for 24-48 hours. Apply PLAMUR FINISHER MDF to obtain a smoother surface. Sandpaper and follow up with the recommended coating system.
Alluminium & Light Alloys-Fibreglass-Cement. Remove mechanicaly any oxidized layer from the substrate. Remove dust and degrease with THINNER 765. Apply one coat of EPOFOND AM-9 primer. After 12 hours sandpaper and apply EPOXY LIGHT FILLER NS and let dry for 24-48 hours. Apply PLAMUR FINISHER MDF to obtain a smoother surface. Sandpaper and follow up with the recommended coating system.
| Paint Type | Two components |
| Binder type A | Epoxy modified |
| Binder type B | Ammine adduct |
| Code & colour A | 7F6332 |
| Code & colour B | 8Z6333 |
| Specific gravity kg/lt (±0,05) | 1.540 (Sol.A) - 0.980 (Sol.B) |
| Solids content (volume) ±2 | 100% |
| Viscosity Ford ø 8 at 20°C ±2 | Tixotropico (A+B) |
| Shelf life +23°C (±2) | 30 months in unopened cans |
| Viscosity Ford (Ø4 a 20°C) | Tixotropic (A+B) |
| Application | Spatula |
| Mixing ratio A+B by volume | 1 part Sol.A with 1 Sol.B |
| Sandable | After 24 hours |
| Touch dry | 6-8 h ( 20°C) |
| Spatula | Ready to use |
| Recoat time | Minimum 24-36 h (20°c) |
| Application temperature | Between +10 C and +40 C |
| Relevant humidity | Less than 80% |
| Dry film thickness advised | 300 microns per coat |
| Theoret. coverage m2/Lt | 4 for a thickness of 250 microns |
Colors: GRIGIO
Color code: 7F6332
Before starting paint application please carefully read all the safety precautions indicated on the label of each can or in the product safety data sheet available on request. For further information please do not hesitate to contact our technical staff.
The above information is given to the best of our current knowledge, however, because the conditions of use of our products are beyond our control, no warranty is given or to be implied in respect of such information. Our technical staff can be contacted to study customer's specific requirements involving our products in order to enable their most effective use. Dilution rates and drying times must be considered only indicative, mainly related to a temperature of 20 ° C (68°F) and may vary according to prevailing temperature, in presence of particular weather conditions or depending on application procedures.
Seguici su
Tel:
Fax:
Email -
PEC -
© Aemme Colors 2022 - All rights reserved.
Cookie Policy - Privacy Policy