enamels
Home - Products - Marine Line - Yachting Line - enamels - Interno Scafi / Bilge paint
Interno Scafi / Bilge paint

Interno Scafi / Bilge paint

pdf-icon
Code: 4S3909

One-component product specifically formulated for application on interiors of hulls to provide adequate protection on steel, fibreglass or wooden boats. It is a fast drying paint with excellent resistance to sea water and fuels. Recommended for bilges, floors and engine rooms. Two coats application is recommended. Available in grey or white finish.

SURFACE PREPARATION AND APPLICATION PROCEDURE

Bare Steel. The substrate should be clean, dry and well degreased. Remove trace of corrosion and apply 1 coat of EVIOX CROMOMINIO Overcoat then with 2 coats of INTERNO SCAFI / BILGE PAINT allowing 18-24 hours between coats.

Bare Wood. The surface should be clean, dry and well seasoned. If necessary apply 1 coat of EVIOX CROMOMINIO  diluted up to 30-40% and let dry for 12-24 hours. Overcoat with 2 coats of INTERNO SCAFI / BILGE PAINT allowing 18-24 hours between coats.

Previously Painted surfaces.
- If the old paint is in poor condition, loose or powdery, it should be mechanically removed and procedure as per Bare substrate should be followed in such event.
- If the old paint is in good condition and it only needs a topcoat because it is dull or dirty but with the underneath coatings still well fixed to the substrate, degrease and sandpaper with medium-fine abrasive paper the surface; remove dust, clean well and apply 2 coats of INTERNO SCAFI / BILGE PAINT allowing 18-24 hours between coats.

Paint Type One component
Binder type A Alkyd modified
Specific gravity kg/lt (±0,05) 1.420
Solids content (volume) ±2 45%
Viscosity Ford ø 8 at 20°C ±2 14-16 sec.
Shelf life +23°C (±2) 30 months in unopened cans
Application Brush-Roller-Spray
Brush-Roller 5-10% Thinner 400
Spray 10-30% Thinner 900
Dust dry 2 hours
Recoat time 18-24 h (20°c)
Application temperature Between +10 C and +40 C
Relevant humidity Less than 80%
Dry film thickness advised 40-50 microns per coat
Theoret. coverage m2/Lt 10-12

Colors: BIANCO
Color code: 4S3909

Colors: GRIGIO
Color code: 4S4478

SAFETY PRECAUTIONS

Before starting paint application please carefully read all the safety precautions indicated on the label of each can or in the product safety data sheet available on request. For further information please do not hesitate to contact our technical staff.



NOTES

The above information is given to the best of our current knowledge, however, because the conditions of use of our products are beyond our control, no warranty is given or to be implied in respect of such information. Our technical staff can be contacted to study customer's specific requirements involving our products in order to enable their most effective use. Dilution rates and drying times must be considered only indicative, mainly related to a temperature of 20 ° C (68°F) and may vary according to prevailing temperature, in presence of particular weather conditions or depending on application procedures.