Recommended for restoring damp wall surfaces. Stops and seals humidity from walls surfaces, reduces flowering problems on plasters and avoid lifting of subsequent coatings (e.g. water-based or solvent based paints, wall papers etc.). Particularly recommended for underground rooms with poor ventilation subject to humidity. Removing dump from the walls, which is the first reason of mould growing, means reducing the possibility for such problem to take place while helps maintaining rooms healthy.
SURFACE PREPARATION AND RECOMMENDED COATING SYSTEM
New walls. Concrete, chalk or plaster bare walls should be dusted off in order to remove all loose particle from the substrate before painting. Apply one direct coat of UMICONTROL thinned 20% with Thinner 400. Let dry for 24 hours and apply a second coat of UMICONTROL thinned 10% with Thinner 400.
Damp walls. If there are traces of mould on the surface, one full coat of LINDOS ADV70 should be priorly applied; let stand for 24 hours. When dry wirebrush vigorously the surface to remove the passivated mould and any loose particles from the walls. Apply one direct coat of UMICONTROL thinned 10% with Thinner 400 and provide ventilation into the room. Let dry for 24 hours and apply a second coat of UMICONTROL thinned 10% with Thinner 400.
Paint Type | One component |
Binder type A | Acrylic |
Solids content (weight) ±2 | 67% |
Viscosity Ford ø 8 at 20°C ±2 | 24-25 |
Shelf life +23°C (±2) | 24 months in unopened cans |
Note | Keep in a cool, dry place, protect from frost |
Application | Brush-Roller-Spray |
Brush-Roller | 10-30% Thinner 400 |
Spray | Airless Spray 10-30% Thinner 400 |
Recoat time | 24 h |
Relevant humidity | Less than 80% |
Dry film thickness advised | 40 dry microns per coat |
Theoret. coverage m2/Lt | 8-10 |
Colors: BIANCO
Color code: 7I4930
Before starting paint application please carefully read all the safety precautions indicated on the label of each can or in the product safety data sheet available on request. For further information please do not hesitate to contact our technical staff.
The above information is given to the best of our current knowledge, however, because the conditions of use of our products are beyond our control, no warranty is given or to be implied in respect of such information. Our technical staff can be contacted to study customer's specific requirements involving our products in order to enable their most effective use. Dilution rates and drying times must be considered only indicative, mainly related to a temperature of 20 ° C (68°F) and may vary according to prevailing temperature, in presence of particular weather conditions or depending on application procedures.