Home - Products - Industry Line - Neutral one component Converters - Synthetic Gloss Enamel (Binder)
Synthetic Gloss Enamel (Binder)

Synthetic Gloss Enamel (Binder)

pdf-icon

Code: 2DNE00

Gloss enamel for wood and steel for interior and exterior use. It should applied on substrates previously prepared with suitable basecoat or old paints in good conditions.

SURFACE PREPARATION AND APPLICATION
Wood, Steel Plasters:
New substrates:
Apply a suitable primer, according to the kind of substrate to be coated (anticorrosion primer for steel, impregnating varnish for wood or wall sealer for plaster). Overcoat with 2 coats of  SYNTHETIC GLOSS ENAMEL allowing 24 hours between coats.
Painted substrates: It is recommended that any loose or flaking paint should be removed. Touch up where necessary the bare surface with suitable primer. Overcoat with 2 coats of SYNTHETIC GLOSS  ENAMEL allowing 24 hours between coats.

Paint Type One component
Binder type A Long oil alkyd
Specific gravity kg/lt (±0,05) 1.065
Solids content (weight) ±2 58%
Shelf life +23°C (±2) 30 months in unopened cans
Viscosity Ford (Ø4 a 20°C) 180-210 sec.
Application Brush-Roller-Spray
Brush-Roller 10-20% Thinner 107
Spray 10-25% Thinner 900
Dust dry 2 hours
Recoat time 24 h
Application temperature Between +10 C and +40 C
Relevant humidity Less than 80%
Dry film thickness advised 40 microns per coat
Theoret. coverage m2/Lt 9-10
Mixing ratio A+B 65 parti di Neutro con 35 di Paste coloranti (in peso)
Colour mixing by weight 65 parts of Binder with 35 parts of Colouring pastes (by weight)

Colors: NEUTRO
Color code: 2DNE00

SAFETY PRECAUTIONS

Before starting paint application please carefully read all the safety precautions indicated on the label of each can or in the product safety data sheet available on request. For further information please do not hesitate to contact our technical staff.



NOTES

The above information is given to the best of our current knowledge, however, because the conditions of use of our products are beyond our control, no warranty is given or to be implied in respect of such information. Our technical staff can be contacted to study customer's specific requirements involving our products in order to enable their most effective use. Dilution rates and drying times must be considered only indicative, mainly related to a temperature of 20 ° C (68°F) and may vary according to prevailing temperature, in presence of particular weather conditions or depending on application procedures.