Home - Products - Industry Line - Antirust - Epoxvin AM/11
Epoxvin AM/11
Code: 5F0000
Two-component, semi-gloss epoxy coating, modified with vynil copolymers. It can be applied at high thicknesses. Usually applied as an intermediate coat in heavy duty carpentry for exposure to normal industrial or marine environments. Provides all the specific charactheristics of an epoxy coating and can be easily overcoated.
SURFACE PREPARATION AND APPLICATION
Steel/Iron
Sandblasting according to SA 2,5 is recommended. If sandblasting cannot be carried out proceed with a a mechanical sanding; the substrate should be perfectly clean, dry and free from corrosion. Onto polyurethane or zinc based epoxy primers apply una coat of EPOXVIN AM/11 followed by two coats of POLIFOND. Overcoat then with the required finish.
| Paint Type | Two components |
| Binder type A | Epoxy vinyl co |
| Code & colour A | 5F Light Grey |
| Code & colour B | 8ZEPUV Transparent |
| Specific gravity kg/lt (±0,05) | 1.600 (A) - 0.980 (B) |
| Solids content (weight) ±2 | 68% |
| Viscosity Ford ø 8 at 20°C ±2 | 14 sec. |
| Shelf life +23°C (±2) | 30 months in unopened cans |
| Note | Store in a cool and dry place. Do not store at low temperatures. |
| Application | Brush-Roller-Spray |
| Mixing ratio A+B by weight | 100 parts of Sol.A with 20 Sol.B |
| Pot life A+B (20°C) | use within 4 hours |
| Brush-Roller | Fot touch ups: 5-15% Thinner 765 |
| Spray | 10-30% Thinner 765 |
| Touch dry | 4-5 h |
| Recoat time | Minimum 12 h (20°C) |
| Application temperature | Between +10 C and +40 C |
| Relevant humidity | Less than 80% |
| Dry film thickness advised | 50-60 microns per coat |
| Theoret. coverage m2/Lt | 6-7 |
Colors: GRIGIO
Color code: 5F0000
SAFETY PRECAUTIONS
Before starting paint application please carefully read all the safety precautions indicated on the label of each can or in the product safety data sheet available on request. For further information please do not hesitate to contact our technical staff.
NOTES
The above information is given to the best of our current knowledge, however, because the conditions of use of our products are beyond our control, no warranty is given or to be implied in respect of such information. Our technical staff can be contacted to study customer's specific requirements involving our products in order to enable their most effective use. Dilution rates and drying times must be considered only indicative, mainly related to a temperature of 20 ° C (68°F) and may vary according to prevailing temperature, in presence of particular weather conditions or depending on application procedures.
